If
A single node that checks a condition and has two outputs — TRUE and FALSE. Wire each output to the commands for that branch (no separate Else / End If commands needed).
개요
If은(는) AutoFlowRPA의 Conditions 카테고리에 속한 노코드 자동화 단계입니다. 조건에 따라 워크플로를 서로 다른 경로로 분기합니다. 3개의 매개변수를 설정해 동작 방식을 정확하게 제어할 수 있습니다. 비주얼 빌더에서 워크플로로 끌어다 놓을 수 있는 340개 명령 중 하나이며, 스크립트가 필요 없습니다.
기능 소개
A single node that checks a condition and has two outputs — TRUE and FALSE. Wire each output to the commands for that branch (no separate Else / End If commands needed).
파라미터
| 파라미터 | 유형 | 필수 | 기본값 | 설명 |
|---|---|---|---|---|
| First value | string | 필수 | Left-hand operand. 예시: {{{count}}} 변수 지원 | |
| Condition | dropdownis equal to · is not equal to · is greater than · is less than · is greater than or equal to · is less than or equal to · contains · does not contain · is empty · is not empty | 필수 | is equal to | Comparison to perform. |
| Second value | string | 선택 | Right-hand operand. 예시: 10 변수 지원 |
If 사용 방법
- 1
AutoFlowRPA를 열고 Conditions 그룹에서 If 명령을 캔버스로 드래그하세요.
- 2
사이드 패널에서 파라미터를 설정하세요 — If에는 설정 가능한 항목이 3개 있습니다.
- 3
워크플로에 연결한 뒤 Run을 누르세요. 모든 작업이 내 컴퓨터에서 로컬로 실행됩니다.
자주 묻는 질문
If 명령은 무엇을 하나요?
A single node that checks a condition and has two outputs — TRUE and FALSE. Wire each output to the commands for that branch (no separate Else / End If commands needed).
If 명령은 어느 그룹에 속하나요?
If은(는) Conditions 그룹에 속합니다. AutoFlowRPA는 코드 없이 조합할 수 있는 340개 이상의 바로 쓰는 명령을 제공합니다.
If 명령에 파라미터가 있나요?
네 — If에는 설정 가능한 항목이 3개 있으며, 모두 비주얼 노드 에디터에서 편집할 수 있습니다.